We provide evaluation test machines for research divisions of companies and apparatuses used in experiments and training at universities.
Test machines and inspection machines
Electric cart torque test machine
Torque test machine used in training at engineering and electrical engineering departments.
Rear wheel measuring section
Small chassis platform is built on rear wheel and torque measurement for electric cart is performed.
Frictional wear test machine
Surfaces of resins are coated with sample lubricant to measure frictional resistance under pressurized rotation.
Measuring section
Depending on the type of sample, frictional resistance under normal temperature and high temperature, or wear progression of resin is measured.
Low temperature torque test machine
Grease performance below freezing temperature is measured.
Inside of measurement low temperature tank
Grease resistance fluctuation within bearings set to jig is measured.
Bowden test machine
Coefficient of friction of lubricant film on the surface of sample is measured.
Back and forth sliding motion measurement section
Test piece is pressurized on sample surface to repeat back and forth sliding motion from which the fluctuation in frictional resistance value is measured.
Shell-type four-ball extreme-pressure lubricant test machine
Two types, instant extreme pressure (EP) and long duration light load (WEAR), can be measured.
Measuring container and test piece
The wear mark and load carrying capacity of the test piece is measured by putting the sample grease or lubricant in the 3 hard balls of the test piece and adding load and rotation from above with hard balls.
High temperature bearing test machine
Grease degradation with high temperature range is measured.
In-tank double-linked bearing set jig component
10 pieces of bearings pressurized with jig is set to measure the status of grease degradation under high temperature and long duration.
Resonance experimentation jig
Sound or resonance data is collected by adjusting the width and thickness of the slit.
Assembly diagram
Design was based on the request of a professor of engineering/mechanical engineering department.
Single handle 4-axis rotational bending fatigue test machine (existing)
An old test machine installed in the material dynamics lab of an engineering department.
Single handle 4-axis rotational bending fatigue test machine (modified)
An existing test machine from the lab was overhauled.
Existing/test piece set component.
The existing test piece set component was a method of holding the test piece down from the outside with a set bolt, but the occasional loosening prevented stable data.
Modified/test piece set component
The spindle shaft was newly created to switch over to the collet chuck method.
As a result of switching the collet sleeve, test pieces with different diameter can be set.
Spark unit performance inspection apparatus
Inspection line to perform continuous inspections of electrical current, voltage, and waveform of the spark unit all the way to packing.
Small back and forth sliding motion test machine
Measures, through back and forth sliding motion, the frictional resistance of the sample under light load.